Difference: JRichEcControl (8 vs. 9)

Revision 92015-09-23 - StephenWotton

Line: 1 to 1
 
META TOPICPARENT name="LHCbRICH"

JRichEcControl GUI

Line: 30 to 30
  The Expert DAQ panel is opened from Settings->Expert DAQ. The MAC address and IP address that are shown in the panel should correspond to the ethernet port on the DAQ PC. These addresses can be set in the JRichEcConfigurator through the Settings->PC network... panel, and should not need to be changed once the system is configured.
Changed:
<
<
During beamtests, the number of MEP events per ethernet packet was increased to reduce the network packet loss. The optimal setting is probably the maximum number of events that will fit in a single Ethernet fragment. In this firmware the fragment buffer is around 1kb so up to about 30 events per MEP is optimal.
>
>
During beamtests, the number of MEP events per ethernet packet was increased to reduce the network packet loss. The optimal setting is probably the maximum number of events that will fit in a single Ethernet fragment. In this firmware the fragment buffer is around 1kb so up to about 16 events per MEP is optimal.
 

DB pulser

 
This site is powered by the TWiki collaboration platform Powered by PerlCopyright & 2008-2019 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding TWiki? Send feedback