Difference: L0MuonHowToSPYD (2 vs. 3)

Revision 32007-10-01 - JeanPierreCachemiche

Line: 1 to 1
 
META TOPICPARENT name="L0Muon"
-- JeanPierreCachemiche - 27 Sep 2007
Line: 17 to 17
 
  • Double click on PB_Spyd_Test_Load_Ram : the command is dispayed in the caption at the bottom of the page;
  • Click on the Send Parallel CMD button to launch the command in parallel on all the processing boards;
  • At this time the a yellow led is highlighted in front of each board during the whole duration of the programming (approximately 5 minutes);
Changed:
<
<
  • When the programming is over, a green led is highlighted in front of each board : at this time all the processing boards are programmed.
>
>
  • When the programming is over, the yellow led turns to blue for each board : at this time all the processing boards are programmed.
  Controller board programming:
  • Unselect all the processing boards by clicking the CLR button under the selected crate;
Line: 26 to 26
 
  • Double click on CB_Spyd_Test_Load_Ram : the command is dispayed in the caption at the bottom of the page;
  • Click on the Send Parallel CMD button to launch the command on the controller board;
  • At this time the a yellow led is highlighted in front of the board Nr 15 during the whole duration of the programming (approximately 2 minutes);
Changed:
<
<
  • When the programming is over, a green led is highlighted in front of the board : at this time the controller board is programmed.
>
>
  • When the programming is over, the yellow led turns to blue for each board : at this time the controller board is programmed.
  Then Launch the SPYD test.
 
This site is powered by the TWiki collaboration platform Powered by PerlCopyright & 2008-2019 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding TWiki? Send feedback