Optical Position Sensor Tests on SPS Prototype
1. Tests on Laboratory:
Tests Performed on 14/01/2015:Folk on free movement as a pendulum (Measurements taken
ClockWise and
CounterClockWise)
Motivation: Asses the good status of the optcial disk and Optical Position Sensors Calibration
Outcome: 1. Only Slave sensor could be tested and its signal processed.
2. Disk is OK on the area studied (since it's a pendulum movement a complete revolution is not seen)
3. Alignment of both focusers OK
Script Used:
|
|
Figure 1: Optical position sensor Test setup |
Figure 2: Scanner on detail |
|
|
Figure 3: Scan Slave Sensor Clockwise_0 |
Figure 4: Scan Slave Sensor Clockwise_1 |
|
|
Figure 5: Scan Slave Sensor Clockwise_2 |
Figure 6: Scan Slave Sensor Clockwise After disk cleaning_0 |
|
|
Figure 6: Scan Slave Sensor Counter Clockwise_0 |
Figure 7: Scan Slave Sensor Counter Clockwise_1 |
|
|
Figure 8: Scan Slave Sensor Counter Clockwise After disk cleaning _0 |
Figure 8: Scan Slave Sensor Counter Clockwise After disk cleaning and Readjust |
Topic revision: r2 - 2015-12-12
- unknown