Forum on Tracking Detector Mechanics 2014

(Proposed) Speaker: DUARTE RAMOS, Fernando (CERN)

Status: Accepted

Title: Cooling studies for the CLIC vertex detector


The strict requirements in terms of material budget for the CLIC vertex detector (0.2% X0 per detection layer,
including cables and supports) require the use of a dry gas for the cooling of the respective sensors. This, in conjunction
with the compactness of the inner volumes, poses several challenges for the design of a cooling system that is able to fulfill
the required detector specifications. This presentation introduces a detector cooling strategy using dry air as a coolant
and shows the results of computational fluid dynamics simulations and experimental measurements used to validate the proposed strategy.

(Proposed) Speaker: NUIRY, Francois-Xavier (CERN)

Status: Accepted

Title: Optimisation studies and tests of low-mass support structures for the CLIC vertex detector


This talk follows the first one proposed by Fernando Ramos about the CLIC Vertex detector design, general requirements and thermal aspects. A vertex detector with a barrel and an end-cap section, both composed of three double layers, is under development for CLIC. The strict requirements in terms of material budget (2 x 0.2% X0 per double layer, including 2 x 0.1% X0 of silicon for the sensors and readout) necessitate the development of novel low-mass support structures. This presentation focuses on optimisation studies and tests of ultralight full sandwich and open structures (staves) for the CLIC vertex barrel detector. Particular emphasis is put on stave stiffness studies (optimisation and measurements through 3-point bending tests) in view of the maximization of its eigenfrequencies. The mechanical studies, spanning from the stave prototyping program to vibrations studies in a wind tunnel, are shown. Mechanical simulations are compared with measurements on prototypes. In particular high modulus carbon fibres and low-density core materials are studied, as well as the corresponding assembly processes. The amount of material in terms of radiation length is calculated and compared for different stave designs and materials.

-- IvankaBJ - 20 Mar 2014

Topic attachments
ISorted descending Attachment History Action Size Date Who Comment
PDFpdf FRAMOS_Forum_Tracking_Detector_Mechanics.pdf r1 manage 8334.4 K 2014-08-20 - 10:02 EvaSicking Slides Fernando
PDFpdf Vertex_Nury.pdf r1 manage 3382.1 K 2014-06-30 - 09:13 MaxChefdeville  

This topic: CLIC > Detector > UpcomingConferences > FTDM
Topic revision: r4 - 2014-08-20 - EvaSicking
This site is powered by the TWiki collaboration platform Powered by PerlCopyright & 2008-2021 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
or Ideas, requests, problems regarding TWiki? use Discourse or Send feedback