F. Gerigk, S. Ramberger, K. Schirm, R. Wegner, P. Ugena-Tirado

CCDTL (F. Gerigk)

• technical specs for support in preparation,
• should soon receive material list from BINP,
• definition of vacuum test procedures for upcoming visit (first week of August) in progress,
• difficulties to get the Helicoflex order out. Discussion on different joint type for the stem/tank connection reverted to the original version (HNRV 120, alu) after discussions with BINP (55 N/mm instead of 165 N/mm for an HN 130 alu joint)

India (F. Gerigk)

• addendum with prices for jacks sent to India,
• technical specs in preparation,
• no news on coupler --> drawings under approval,
• jacks will be yellow,

windows (F. Gerigk)

• vacuum test should be done today!

DTL (S. Ramberger)

• DMP mentions that it tries to approve schedules to August while ESS-Bilbao found that there are only few pieces in production.
• The machining of the rough girder T1S1 advances on schedule. The company for the final machined girder T1S1 has some delays but appears to advance as well.
• CADINOX should be ready for metrology measurements on the tank segment T1S1 in week 27. So far all looks fine.

PIMS (R. Wegner)

• Ni plating of flanges finished (collaborating institute)
• Brazing of flanges for tuners and ports is being performed
• 2 rings of short module are planned to be sent to Julich end of June
• EB welding sample, which was X-ray analysed at CERN, is sent to IPJ to cross-calibrate their setup
• New samples for a final EB welding test have been prepared and are sent to Julich

PIMS (P. Ugena-Tirado)

• The simulations on the tuning ring heights continue. Module 2 is finished and module 12 already started.
• 17juneTuningRingSimulations.pptx: Simulations of tuning rings for PIMS cavities

-- RolfWegner - 17-Jun-2011