CaloFwdCurrentConfigSandbox

Current run Configuration

LAr

Parameter Expected value Number of Samples 4 First sample 2 L1 latency 104 Complex dead time 9/351 Data format Format1 Run Type Results Gain Type 0 (auto) Tower Builder Delay Type 0 (Physics) DSP thresholds (both ADC and Qfactor+time) 127.4 DSP version DSP-17-00-05-j Alternative configurations (not currently in use) can be found here.

The default LAr configuration is with items Calibration and Action inspector disabled.

Tile

Hardware status In LBA56 twelve PMTs are OFF (internal, EVEN = 2,4,...,22,24). (No cell lost due to Tile response reading redundancy). LBC05 is off due to cooling problem. LBA52 if off due to data corruption. LBC48 is running in Emergency Mode (lower HV settings). All the other modules are fully operational.

DCS status (25/August/2016)

Possible Run Configurations

During collisions the high rate settings should be used. The low rate / cosmics settings are used during cosmics data collection and should be enabled if taking cosmics for a long time. The Tile RC is responsible for switching between these two settings.

More details are given in the Tile Training on the Calo Portal and an image of the two configurations is TileDSPSettings.pdf

LUCID

AFP

ALFA

-- VincentPascuzzi - 2017-04-02