This page will be a forum where anyone can post questions regarding High-Granularity Calorimeter (HGCal) modules and components, module assembly and testing, and module assembly center (MAC) setup. New questions should be posted to the Unanswered questions section. Once an answer has been resolved (typically after some discussion,) the question will be moved to the Answered questions section.

---

Page Contents

---

Unanswered questions (post new questions here)

Back to top

Enter your question in the box below, then press "Post question." Please be descriptive!

• haha -- BrunelConstantineOdegard - 2019-05-31
• When will the gantry head pick up tools arrive? -- WilliamGabrielOrtez - 2019-05-31
• Is there a list of all of the National Instruments modules used at UCSB? -- AndrewWhitbeck - 2019-04-18
• Is there a reference for the bellows (corrugated metal tube) that should be used for the gantry head adaptor? -- AndrewWhitbeck - 2019-04-18
• What type of hoses are used for the vacuum lines? (if a part number exists, that would be helpful) -- AndrewWhitbeck - 2019-04-18
• What are the exact model numbers of the Festo vacuum and sensor components? -- AndrewWhitbeck - 2019-04-18
• Do we need the optional analog I/O board (J80) on the A3200 controller to be installed? -- AndrewWhitbeck - 2019-04-18
• Are there specs on the needed dimensions of cabinets for module curing/storage ? -- JohnAlison - 2019-03-19

Answered questions

When will the gantry head pick up tools arrive? The gantry heads components are out of the machine shop. We are waiting on the bellows shipment. We will then install the tool onto our own gantry to qualify before shiping them to other MACs. We expect this to take a few weeks. test Possibly until mid July. I am not sure about the pick up tooling for PCB and sensor. I will check in with Susanne about that -William 5/31

Is there a list of all of the National Instruments modules used at UCSB? There are two NI modules we are using: the NI 9403 and 9476. -William 2019-04-26

Is there a reference for the bellows (corrugated metal tube) that should be used for the gantry head adaptor? We have been using the following: Bellows(P/N: FC-15): https://servometer.com/products/electroformed-metal-bellows/standard-bellows-sizes/ -William 5/31

Do we need the optional analog I/O board (J80) on the A3200 controller to be installed? No, we do not use that for our A3200 controller at UCSB. -William 5/31

What are the exact model numbers of the Festo vacuum and sensor components? We are using the FESTO CPV10-V1 valves. Currently, UCSB is using four Festo valves. For the sensors we are using the Festo VPEV model vacuum sensor. -William 5/31

What type of hoses are used for the vacuum lines? We are using the festo PUN-6X1 vacuum tubing. -William 5/31

Are there specs on the needed dimensions of cabinets for module curing/storage? The outer dimensions of the curing cabinet is 3'x2'x6.5' -William 5/31

-- BrunelConstantineOdegard - 2019-02-26