Setups: 4 fibers from router to router checker;

Twinax cable from rim L1DDC to router;

Twinax cable from rim L1DDC to clock;

Router checker: 6V (2A) for voltage and 160MHz clock (pin J15 and J16)

Router (2A) and L1DDC (1A): 10V for voltage

Configure FEBs:







Make sure prbs disabled

Setup Router and Router checker firmware

Use Jtag to config them

For router checker: using bit_092520_ila40

For router: change modelflag_vector to 53C9, ctrlmod_vio to 3


For router checker:

Reset using Soft_reset_vio (Active High button) from hw_vios


Data: 4bit header followed by 8bit band-id, 5bit phi-id and 6bit BCID

Using 2017.2 Vivado

-- YanlinLiu - 2020-10-09

This topic: Sandbox > WebPreferences > TriggerChainTestwithRouterChecker
Topic revision: r1 - 2020-10-09 - YanlinLiu
This site is powered by the TWiki collaboration platform Powered by PerlCopyright & 2008-2020 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
or Ideas, requests, problems regarding TWiki? use Discourse or Send feedback